mayanoob.blogg.se - Cisco secure access control system 1120 appliance

#Cisco secure access control system 1120 appliance how to#
#Cisco secure access control system 1120 appliance install#
#Cisco secure access control system 1120 appliance full#

If you notice some binding, recheck the mounting positions. Move the slide rail in and out throughout its entire range of motion and make certain it does not bind. Press the slide extension release levers to release the lock. Step 5 Extend the slide rail to its fully extended (locked) position. Step 4 After ensuring that the proper mounting holes on the rack upright are selected, repeat Step 2 at the slide rail front-mounting position. The rack hole into which the top pin was inserted does not align with one of the RU holes. Press the pins together and insert the rack-mounting end of the multi-pin adapter through the corresponding holes in the bracket. position, as shown in the illustration at the left in Figure 3-2. Rotate the swivel lock to the up position. Step 3 Repeat Steps 1 and 2 for both ends of each slide rail.Ī. Ensure that both mounting pins on the multi-pin adapter are fully engaged in the multi-pin bracket, then lock the multi-pin adapter in place using the swivel lock. The multi-pin adapter must be fully locked in the bracket.

#Cisco secure access control system 1120 appliance install#

Step 2 Install the multi-pin adapter by pressing the pins together while inserting the adapter into the bracket. Remove the multi-pin adapter by rotating the swivel lock upward, pressing the mounting pins together, and then pulling the adapter from the multi-pin bracket. Step 1 On each slide rail, reverse the multi-pin adapter position to match the rack-mounting hole type, if necessary. The multi-pin adapters allow the slide rails to be used in racks that have square mounting holes or round mounting holes.

Installing and Securing the Slide Rails in a Rack.

Setting the Multi-Pin Adapters for the Rack Type.

Proceed to the next section, Installing the Slide Rails into a Rack with Square Holes, to continue the installation process. To access the features of the innermost piece, such as the release levers, you must grasp the end of the innermost piece and pull it firmly out of the piece that contains it.

#Cisco secure access control system 1120 appliance full#

Note Each rail consists of three pieces that slide to extend the rail to its full length.

Removing or Replacing the CSACS 1120 Series Applianceīefore you begin the installation, read the Regulatory Compliance and Safety Information for the Cisco 1120 Secure Access Control Server 4.2 and the Site Preparation and Safety Guide that is shipped with your appliance.Powering Up the CSACS 1120 Series Appliance.

Mounting the CSACS 1120 Series Appliance in a 4-Post Rack.

#Cisco secure access control system 1120 appliance how to#

This chapter describes how to install your CSACS 1120 Series appliance and connect it to the network. Removing or Replacing the CSACS 1120 Series Appliance Powering Up the CSACS 1120 Series Appliance Installing the Appliance into the Slide RailsĬonnecting the Keyboard and Video Monitor Installing the Slide Rails into a Rack with Round Holes Installing and Securing the Slide Rails in a Rack Setting the Multi-Pin Adapters for the Rack Type Installing the Slide Rails into a Rack with Square Holes Mounting the CSACS 1120 Series Appliance in a 4-Post Rack Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2